Diferencias
Muestra las diferencias entre dos versiones de la página.
| Ambos lados, revisión anterior Revisión previa | |||
| doc:tec:lab:tester:lab_ztdq02:inicio [2026/07/15 14:12] – euloxio | doc:tec:lab:tester:lab_ztdq02:inicio [2026/07/15 14:15] (actual) – [Bridge Calibration] euloxio | ||
|---|---|---|---|
| Línea 42: | Línea 42: | ||
| - For 10mΩ and 100mΩ standard resistors, it is recommended to use 4-wire resistors. | - For 10mΩ and 100mΩ standard resistors, it is recommended to use 4-wire resistors. | ||
| - For OPEN calibration, | - For OPEN calibration, | ||
| + | \\ | ||
| + | ==== Internal Resistance Calibration ==== | ||
| + | |||
| + | Enter the settings menu and select " | ||
| + | |||
| + | - Use the left and right keys to select the resistance or voltage value to calibrate, connect the corresponding standard source, and press the AUTO key to begin calibration. The screen' | ||
| + | - The calibration process will take a few seconds,so please be patient. | ||
| + | - Calibration results: Green indicates OK, Red indicates NG. | ||
| + | |||
| + | **Notes:** | ||
| + | - Use non-inductive resistors for calibration. Do not use wound resistors. | ||
| + | - For 10mΩ and 100mΩ standard resistors, it is recommended to use PBV 4-wire resistors. | ||
| + | - Voltage calibration requires a standard DC voltage source. | ||
| + | |||
| + | **Additional Notes:** | ||
| + | - Although this product provides an open user calibration learning mode, it has been 100% calibrated before leaving the factory, and no additional calibration is necessary for users. If calibration is required in special situations, the above method can be followed. | ||
| + | - If calibration values are inaccurate or distorted, simply restore the factory settings to return to the factory calibration values. | ||
| \\ | \\ | ||